Important points for fitting and removal
Caution
Please use suitable personal protective equipment (PPE)
For model specific requirements, please follow car manufacturer installation instructions
In this video the focus is on the first generation type wheel bearing without a magnetic encoder seal. The example shown here is for a front wheel bearing from a 2006 Toyota Corolla.
Tip: It is better not to use an impact wrench to avoid damage to the driven shaft
Tip: This helps to prevent damage to the drive shaft threads and is also a reason to discard the nut
Tip: In case the nut is rotating with the ball joint, press the ball joint further into the knuckle arm. The nut can now be loosened
Tip: If you don’t have a dedicated tool as shown, or a ball joint splitter, do not hammer the ball joint directly. It is possible to hammer the end of the knuckle mounting arm lightly to loosen and remove the ball joint.
Tip: For safe removal ensure that there is enough contact between the end face of the inner ring and the separator.
Tip: Keep the inner ring to press out the bearing in the next step.
Tip: By cleaning the parts before assembly the mounting is less problematic and premature failure can be avoided.
Tip: Only remove the bearing from its protective packaging immediately before the fitting.
Tip: Outer diameter of tool < outer diameter of bearing
Tip: Never press the inner ring to insert the bearing
Tip: Torque settings can vary significantly between car models. Therefore check the manufacturer values.
Tip: In case the nut is rotating with the ball joint, press the ball joint further into the knuckle arm. The nut can now be tightened.
Tip: The use of an impact wrench can result in demage of the CVJ internals
Tip: Ensure the brake hose has not be twisted or damaged.
Tip:
ProKIT is NSK's range for the Independent Automotive Aftermarket.
NSK ProKIT packages contain all components you need when replacing wheel bearings >>